Simple walk through on making the collars for these keyed wedges. 3/16×1"1/4" flat bar. Lay out where my bends will happen. Most of this is at the vise with controlled heats and setting up everything square. Hammer control is important as you don't want to set these crooked. The last step is to start the second bend, heat again and squish in the vise. A little clean up with the hammer but minor over all. #blacksmithing #dirtysmith #forgingFridays #IknowItsNotFriday #ButWeAreDoingSHookChain

Colorado Artist Blacksmith - Dragon Forge LTD